The project driver .. need some information!!

[harpo_72]

Right I have had a few threads on here about looking at running a driver with 12 degrees loft and a low launch/ low spin shaft. Well the components are in but something a bit strange..
I bought an SMT Nemesis head off ebay and it has all the details like weight/lie/loft.. but it has a screw thread in the hosel? Has anyone got experience of these ? (I know its old, but I like a small head that is deep not wide)
Also it says it takes the shaft 2" into the head, surely this will affect the tip stiffness? Or is this quite normal for a head?
Any comments or experience with these?

The shaft to be inserted is a Arthur Xtreme Excalibur 6+ in stiff ... which with the fitting could be too much !

 

[Foxholer]

Check this site out.

http://www.smtgolf.com/clubBuilders.asp

Then contact one of their Club Builders for info.

Good company. Their wedges are pretty good too - as I hope Jimbob_S onfirms this weekend!

 

[harpo_72]

Yes been on there several times managed to find something called faz fit ... But I think it will just get glued on using beads to sit in the thread ..

 

[harpo_72]

The shaft has been measured at 262cpms, which made me initially think it was going to be a little too much when the NV 65 s was measured at 248cpms. However I have been using a Fubuki 63 stiff in the 910 and an axivcore tour green at 69g both of which are said to be in excess of 258cpms .... So today I will find out!