UST frequenct filter puuter shaft

[Taz]

Want to take my putter down another inch but its fitted with one of these :

http://www.ustmamiya.com/golf-shafts/putters/frequency-filtered

Should I get a pro to do this or has anyone cut these with a saw (or some other suitable tool) ?

 

[GreiginFife]

Suitable for butt trimming, pipe cutter same as I would use on iron shafts. Would only use a saw if it was a cut off blade, hacksaw likely to leave a nasty sharp edge that would need ground out.

 

[Foxholer]

Want to take my putter down another inch but its fitted with one of these :

http://www.ustmamiya.com/golf-shafts/putters/frequency-filtered

Should I get a pro to do this or has anyone cut these with a saw (or some other suitable tool) ?

I got a Pro (Fitter) to do it when I installed one in a 'Hoganardi' head, but it's simply a case of butt-trimming to the desirable length.

 

[Taz]

Suitable for butt trimming, pipe cutter same as I would use on iron shafts. Would only use a saw if it was a cut off blade, hacksaw likely to leave a nasty sharp edge that would need ground out.

I use something like this for SS shafts, would this be ok ?

https://www.amazon.co.uk/Draper-Exp...&qid=1462967966&sr=8-3&keywords=tubing+cutter

 

[Foxholer]

I use something like this for SS shafts, would this be ok ?

https://www.amazon.co.uk/Draper-Exp...&qid=1462967966&sr=8-3&keywords=tubing+cutter

Absolutely perfect! That's what the guy that did mine used!

 

[GreiginFife]

I use something like this for SS shafts, would this be ok ?

https://www.amazon.co.uk/Draper-Exp...&qid=1462967966&sr=8-3&keywords=tubing+cutter

Exactly what I use. Even the same make.