iPing Cradle Wanted

[Region3]

Does anybody have the cradle for the iPhone Ping putting app that they want to offload?

I know you can make one, but stuff like that isn't my strong point!

Thanks.

 

[G1BB0]

21 quid new.... rip off lol. I want one though so may end up buying new

 

[Rooter]

It is so easy to make one guys...

buy a £1 iphone case from a rubbish shop.

Drill 4 holes in the back

loop 2 cable ties through the holes and zip tie to the putter. once you are done, cut them off.

Et Voila!




I should be in product design... i could charge loads for that diagram!!

 

[CMAC]

It is so easy to make one guys...

buy a £1 iphone case from a rubbish shop.

Drill 4 holes in the back

loop 2 cable ties through the holes and zip tie to the putter. once you are done, cut them off.

Et Voila!

View attachment 4466


I should be in product design... i could charge loads for that diagram!!

excellent idea:thup:

I must remember to take the iPhone out the case before drilling 4 holes through it though:smirk:

 

[Rooter]

"I-Ting Putter Thing enterprises accept no responsibilities for people drilling holes in their iphones, kitchen tables, anything of the wifes or the cat."

 

[bozza]

Or another way to make your own is to buy a cheap iphone case as said above, buy some 15mm open tallon pipe clips and glue it to the back of the iphone case then you can just clip it on and off the putter shaft when you want without having to cut the cable ties off and having to drill holes in the case.

The 15mm pipe clips are slightly too big for a putter shaft but just wedge a little bit of paper in, cost me about £4 to make.

 

[nil1121]

another way which i used is to glue a shaft rubber vice clamp on the back of a cheap iphone case. holds it really well and easy to put on and take off