monktonhallgc1882
Assistant Pro
Probably not worth asking #lostmyown
Wolud a Ping Wrench work in a Titleist club?
- Thread starter monktonhallgc1882
- Start date
ruff-driver
Journeyman Pro
If the ping is like a T.M or nike then yes
JT77
Tour Winner
I think it's a different fit not 100% sure though
Imurg
The Grinder Of Pars (Semi Crocked)
I suspect all shaft screws are the same but the torque settings may vary from manufacturer to manufacturer.... So you may over or under tighten
JT77
Tour Winner
I know for sure the Cleveland one is different from Titleist, and I'm off to check as I have both.
Two tics
Two tics
garyinderry
Ryder Cup Winner
Will be fine.
JT77
Tour Winner
Can't find my Titleist one but the ping one looks similar to what I recall.
dan2844
Assistant Pro
Might sound stupid but can you not just use any Torx bit that matches the head?
D
Deleted Member 1156
Guest
Yes*
*But H&S regulations probably state you MUST use the wrench otherwise the head might fly off and hurt you/PP/greenkeeper/wildlife
Anyone with a modicum of engineering sense can tell if they have tightened the screw to an acceptable torque.
