Shaft length

[KENNYJ100]

HI THERE
i want to change the shaft in my titleist 910 3 wood to a bassara 55 hi reg shaft , to match my driver , ive got another bassara driver shaft from a friend , is it as simple as cutting the grip end down to 3 wood length ? hope to hear your replies

 

[Foxholer]

HI THERE
i want to change the shaft in my titleist 910 3 wood to a bassara 55 hi reg shaft , to match my driver , ive got another bassara driver shaft from a friend , is it as simple as cutting the grip end down to 3 wood length ? hope to hear your replies

Normally there's 1" taken off the tip and then butt is trimmed to required length.Traditional 3-Wood is (10gms or so) heavier than Driver one too. So may need to adjusted a bit more (lead tape at hozel and under grip) and then Swing Weight set.

So a bit more complicated than just cutting the grip end!

Edit: Tipping spec for Bassara 3-Wood appears to be 0.5"