Slazenger K1 Fast Driver Weight Adjustment

[dads3a]

Yes I've still got one of these drivers from when I started off 2 years ago and can't afford to change it for now.

Problem is when I started I had a bad hook, now most things go straightI want to change it back to a neutral swing but have lost the instructions that tell you what weights go where.

Looked online and can't find any instructions anybody know where to get hold of the weight setup from.

Thought of phoning JJB but they don't sell them anymore.

Cheers

 

[Doh]

This is not a solution but if setting up for a draw the heavier weights would be put towards the heel of the club.
If setting up for a fade then they would go towards the toe of the club.

So depending on what weights you have if setting up for a neutral bias I would think that they have to be evenly balanced toe and heel.

 

[Smiffy]

Problem is when I started I had a bad hook, now most things go straight...I want to change it back to neutral

If you are now hitting it straight, why change it?

 

[Adrena1in]

+1 to what both Doh and Smiffy say.

 

[TRS30]

+1 to what both Doh and Smiffy say.

+2

If your hitting it straight then leave it aslone, unless you want to hit a slice that is

 

[andiritchie]

If your club has 3 weights one will be heavier the other two should be the same,just put the heavier one which should be in the heel at the moment into the middle and the other two at each side

 

[dads3a]

Cheers for the advice folks.

The driver is going straight but you can see the slight tail to the left at the end.

Thought maybe as the 3 wood and the irons were straight with no weights in them I might try the driver on a neutral setting.