jamielaing
Q-School Graduate
So I have decided to get myself a new driver and having salivated over the G30 since it was released that is the decision I have come to.
It has come down to the G30 v G30 LS tec.
Either way it will be with a tour shaft and in 9 degrees (altered to 8).
My dilemma is that there is limited places to try Ping's clubs where I am, no one carries the full range for demo. I went to the range and hit the LS in 9.5 with the standard shaft. This went higher and left.
I hit the G30 with a tour shaft in 8 degrees. This went well.
Obvious point would be to change the shafts about but the guy wouldn't give me the tool. I have been fit elsewhere that doesn't have the full range either so, are these results due to the loft and shaft being different in the LS or is the G30 the way to go? The fitter recommended the LS Tec and that has been ordered with the promise of changing the head if I want to after a shot on a launch montor however I do like to see the flight rather than into a net.
Do you give up much in the LS Tec? Or is it exactly the same but lower spin?
Any help/ advice greatly appreciated.
It has come down to the G30 v G30 LS tec.
Either way it will be with a tour shaft and in 9 degrees (altered to 8).
My dilemma is that there is limited places to try Ping's clubs where I am, no one carries the full range for demo. I went to the range and hit the LS in 9.5 with the standard shaft. This went higher and left.
I hit the G30 with a tour shaft in 8 degrees. This went well.
Obvious point would be to change the shafts about but the guy wouldn't give me the tool. I have been fit elsewhere that doesn't have the full range either so, are these results due to the loft and shaft being different in the LS or is the G30 the way to go? The fitter recommended the LS Tec and that has been ordered with the promise of changing the head if I want to after a shot on a launch montor however I do like to see the flight rather than into a net.
Do you give up much in the LS Tec? Or is it exactly the same but lower spin?
Any help/ advice greatly appreciated.