Recent content by Mcleodc2000

Coventry is a really great course! I played there a good bit over last summer, and moving back to the area in September, may well look to join again! Really good mix of holes to make you think

Paid up the other day- can only live in hope for the last couple of medals to at least finish the season well...

£20 paid up for not reaching my Category 1 Objective- nowhere near enough competitions played over the Summer!

Sitting at 6.1 with just a couple left- been away from home and playing a different course, so been a bit trickier to get scoring in on competitions! Hopefully got a couple left to have a run at it

Graeme Bell at East Kilbride is great- just got a new swing lab built with GC Quad as well!

They've got a range, putting green and a couple of chipping/pitching greens which are alright, can't remember how much it was for a basket of balls though

Managed another .4 a couple of weeks back taking me to 5.7, but a couple of very narrowly missed buffers have me sitting at 5.9

Good result yesterday, avoiding the worst of the rain- +2 for a nett 66, down to 6.1!

I've got a place too- just need to hope I can 100% make it!

Sensible thing would probably be to use the V2 since you seemed to get reasonable results with it, and are somewhat familiarised with it. In my opinion though, the rogue silver is a cracking shaft!

I'll give them both an email tomorrow then, see what they can offer me- naturally, I'd rather not have to pay a full yearly fee when I'm only there a couple of months! The two of them both certainly look like nice tracks from their websites

Yeah- essentially it is recordid what happens with the ball and ignoring the club- therfore the ball data will be correct, but the club data could be skewed. If you imagine you're getting ball speeds of 145mph, that'd give you a clubhead speed of 100mph on the nose (145/1.45), but if your smash...

GC2 only measures ball speed, then works to an assumed smash factor of 1.45 (which could be being generous given the pros are about 1.48 average) to calculate the clubhead speed. Without HMT, it doesn't track clubhead speed (just ball speed/1.45 = clubhead speed)

Haven't used Clydebank, but have done East kilbride. For the most part, if you aren't going to be overly particular or spend the money on upcharge shafts, they're not the worst place to go- if you're likely to fit in to a fairly standard reg or stiff shaft, you'll probably have enough to keep...

I'm moving to Coventry for a couple of months over the summer, and looking for a course to join for a couple of months- I emailed the GM at Hearsall yesterday and they've offered quite a favourable rate, so just wanted to ask a couple of questions on it: 1. How's the course, layout and...